Penner Bathing Spas Disinfection Quick Guide

STEP 1

Close and lock spa door.

Install drain plug in drain.

STEP 2

PUSH and HOLD disinfect jets button.

STEP 3

Fill spa floor with disinfectant solution until a depth of 1/4" of solution is achieved.

STEP 4

Using spa brush, dip brush into solution, and scrub entire spa interior along with top and underside of mobile transfer. Allow disinfect to remain on contact for 10 minutes.

STEP 5

Remove drain plug. PRESS and HOLD rinse jet button. Clean water will flush the remaining disinfectant from the jets.

STEP 6

PRESS and RELEASE the Aqua-Aire button allowing warm air to push any remaining water from the lines.

STEP 7

PRESS and RELEASE hand spray button to activate shower sprayer. Starting at the top rim of spa, rinse any remaining disinfectant solution off spa walls and down spa drain. Rinse mobile transfer.

STEP 8

PRESS and RELEASE Aqua-Aire button to turn off warm air. Replace shower sprayer to holder.

Spa disininfection is now complete.

.

Please refer to your Penner Bathing Spas operation manual to answer any additional questions or our link below for a step by step video on spa disinfection.

Created By
Robert Mazza
Appreciate

Made with Adobe Slate

Make your words and images move.

Get Slate

Report Abuse

If you feel that this video content violates the Adobe Terms of Use, you may report this content by filling out this quick form.

To report a Copyright Violation, please follow Section 17 in the Terms of Use.